Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM

Same-day service

Resources · Wolf

Wolf Error Codes

Wolf ovens show a short code when the control detects a fault with the door lock, a temperature sensor, the cooling system or communication between boards. Wolf has used several code formats over the years, so the families matter more than the exact digits.

Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM

Wolf wall ovens and dual-fuel range ovens

Wolf changed its code format between the legacy, E series and M series ovens, so match the family first and the digits second.

CodeWhat it meansWhat to check
Door lock codes (for example 01, 03, or "LOCK" flashing)The door lock did not reach its locked or unlocked position, usually during or after self-clean.Let the oven cool completely, switch the breaker off for five minutes and try again. If the door stays locked, do not force it.
Sensor codes (for example 07, 09 or "OPP")The oven temperature sensor (RTD) or the meat probe is reading open or shorted.Unplug the meat probe if fitted and check its socket is clean. Otherwise the oven sensor needs testing.
Communication codes (for example 0B, 2C21)The display and the power board have lost contact with each other.Cut power at the breaker, wait, and restore it. A code that comes straight back points to wiring or a board.
Overheat or cooling fan codesThe control compartment is too hot, often because the cooling fan has failed.Stop using the oven and book service. Running it can damage the electronics.
High-voltage or relay codes (for example 4022, 0121)The supply voltage is out of range or an element relay has stuck.Needs a technician. An oven that heats when it is switched off must be turned off at the breaker.

Wolf induction cooktops and ranges

CodeWhat it meansWhat to check
E2 or flashing zoneThe zone or the electronics have overheated, or there is no suitable pan.Use induction-compatible cookware, clear the vents under the cooktop and let it cool.
E01, E05, E20 and similarKey, communication or sensor faults in the induction module.Breaker off for five minutes. If it returns, it needs diagnosis.

Codes vary by model and year. If your code is not listed, call (619) 743-9389 with the model number. See also Wolf appliance repair in San Diego.

My Wolf oven door is locked after self-clean. What do I do?

Wait until the oven is fully cool. The lock will not release above a set temperature. If it is cool and still locked, switch the breaker off for five minutes and restore power. If that fails, the lock motor needs replacing.

Where is the exact code list for my Wolf model?

In the use and care guide for your model number, which is on the rating plate inside the oven door frame. Wolf has changed code formats between generations.

Is it safe to use a Wolf oven that shows a fault code?

If the code concerns overheating, a stuck relay or the door lock, stop and switch it off at the breaker. For a probe or sensor code, the oven may still work but will not hold temperature accurately.

Wolf code will not clear? Book a diagnostic.

Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM. San Diego and Orange County.

Call us for a diagnosis.

Call Book online