Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM

Same-day service

Resources · Fisher & Paykel

Fisher & Paykel Error Codes

A Fisher & Paykel DishDrawer tells you it has a fault by beeping continuously and showing a code. The codes fall into two kinds: U codes you can often fix yourself, such as a closed water tap, and E codes that point to a part. The flowchart in the manual starts with one step, pressing the button to stop the beeping.

Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM

DishDrawer U codes (prompts you can check)

On classic models the code shows in the display. On designer and integrated models, the program indicator lights show the code. Try to open the drawer without force first.

CodeWhat it meansWhat to check
U1No water. The water supply has not been turned on.Open the supply tap, then press the button to resume the program.
U4There is a fault in the other drawer that prevents this drawer from running.Deal with the fault on the other drawer. The drawer showing U4 is not faulty.
U6The spray arm has come loose from its mounting, or the water pressure is too low.Open the drawer and refit the spray arm. If it is fine, low water pressure may need a valve change by a plumber.

DishDrawer E codes (fault codes)

Fisher & Paykel says some of these can be reset by pressing the button and waiting a few seconds. If the code returns, disconnect power, turn off the water and call with the code.

CodeWhat it meansWhat to check
E1Flood detected.Turn off the water and power. Look for leaks at the connections and the door seal.
E2Motor fault.This needs a technician.
E3Temperature sensor fault. The incoming water may be hotter than the dishwasher accepts.Incoming water should be below 65 C (149 F). A tempering valve may be needed on the supply.
E4The heating element has failed.This needs a technician.
E5A fault with the internal lid of the dishwasher.This needs a technician.
E6A fault with the drying fan.This needs a technician.
E7 / E8 / E9Electronics faults: detergent dispensing (E7), other systems (E8), controller (E9).Disconnect power for a minute and restart. If it returns, the electronics need testing.
ECElectronics fault: communication between the two drawers.Power cycle both drawers. If it returns, call with the code.

Codes vary by model and year. If your code is not listed, call (619) 743-9389 with the model number. See also Fisher & Paykel appliance repair in San Diego.

Why is my DishDrawer beeping and not starting?

The beeping means the dishwasher has found a fault and is showing a code. Press the button to stop the beep, then look up the code. A U1 is just a closed tap. An E code means a part needs attention.

What does U4 mean on a Fisher & Paykel DishDrawer?

U4 means the other drawer has a fault and is stopping this one from running. The drawer showing U4 is fine. Find the fault on the other drawer and fix that.

Can I fix a Fisher & Paykel E1 flood code myself?

You can turn off the water and power, and check the connections and door seal for a visible leak. Do not keep restarting the dishwasher. If the cause is not obvious, the base needs inspection before it runs again.

Fisher & Paykel code will not clear? Book a diagnostic.

Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM. San Diego and Orange County.

Call us for a diagnosis.

Call Book online