Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM

Same-day service

Resources · Kenmore

Kenmore Error Codes

Kenmore never built its own appliances, so there is no single Kenmore code list. The code you see depends on who made the machine. Look at the first three digits of the model number: 110 and 106 are Whirlpool-built, 795 is LG-built and 253 is Frigidaire-built. Then use the matching list below.

Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM

Kenmore built by Whirlpool (110 and 106 models)

These use the same F and E pairs as Whirlpool. Clear most washer codes with Pause or Cancel twice, then Power once.

CodeWhat it meansWhat to check
F5 E2Washer door is not locking.Check nothing is caught in the door and it closes fully.
F8 E1Washer fill is too slow.Open both taps fully and check the fill hoses are not kinked.
F9 E1Washer is draining too slowly.Check the drain hose for kinks and use HE detergent only.
AFDryer airflow is restricted.Clean the lint screen and check the vent.
Other F# E#A fault that needs diagnosing.Cut power for 5 minutes and restart. If it returns, call.

Kenmore built by LG (795 models)

These use the letter codes you see on LG washers, dryers and refrigerators.

CodeWhat it meansWhat to check
OEThe washer cannot drain.Clean the drain pump filter and check the drain hose.
UEThe washer load is unbalanced.Redistribute the load and avoid washing one heavy item alone.
IEWater is not entering fast enough.Open the taps fully and clean the inlet hose screens.
dEThe door is not closed or locked.Close the door firmly and check for clothing in the seal.
d80 / d90 / d95Dryer exhaust is mostly blocked. The dryer itself is fine.Clean the lint filter and have the vent cleaned from the dryer to outside.

Kenmore built by Frigidaire (253 models)

Top-load Frigidaire-built washers show E1 to E5. Dishwashers show i20 and i40.

CodeWhat it meansWhat to check
E1 / E2Top-load washer is slow to fill (E1) or slow to drain (E2).Check taps and hose screens for E1, the drain hose for E2.
E3The lid is open or the lid lock failed to latch.Close the lid fully and clear anything caught under it.
E4 / E5The load is out of balance (E4) or the washer is not level (E5).Redistribute the load, then level the washer on all four feet.
i20 / i40The dishwasher did not drain (i20) or the filter or sump is clogged (i40).Clean the filter and sump, and check the drain hose and the disposer knockout plug.

Codes vary by model and year. If your code is not listed, call (619) 743-9389 with the model number. See also Kenmore appliance repair in San Diego.

How do I find out who made my Kenmore?

Read the model number on the label inside the door or on the back. The first three digits before the decimal point identify the maker: 110 and 106 for Whirlpool, 795 for LG, 253 for Frigidaire, 363 for GE.

Does my Kenmore error code mean the same as the same code on an LG?

If your model number starts with 795, yes. Kenmore Elite and standard models in that series are LG machines under the Kenmore label. For other prefixes, the same letters may mean something else, so use the matching list.

What if my Kenmore code is not on this page?

Codes vary by model and year. Write down the full model number and the code, and call us. The model number tells us which manufacturer's code table applies.

Kenmore code will not clear? Book a diagnostic.

Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM. San Diego and Orange County.

Call us for a diagnosis.

Call Book online