Appliance installation · San Diego County
Microwave Installation in San Diego
Microwave installation in San Diego starts at $135, with the final price confirmed before we begin. Reset Appliance Repair connects, levels and tests it, and hauls away the old unit when you ask. Book online or call (619) 743-9389.
Reset Appliance Repair installs over-the-range and built-in microwaves in San Diego. An over-the-range unit is heavy and hangs over a hot cooktop, so the job is mostly about solid mounting, the right venting and a safe power connection. We handle all three and test the unit before we leave.
- Starting at $135, confirmed before we start
- Fitted, connected and tested
- Old unit hauled away when you ask
- Same-day service when a slot is open
- Evening appointments available
Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM
Book microwave installation
Tell us the brand if you know it, and your ZIP. We call you back with a time.
Request received.
We will call you back to set a time. Need it sooner? Call (619) 743-9389.
What can go wrong
What goes wrong when a microwave is hung badly
- The top bracket misses the wall studs
- The unit weighs 50 pounds or more. Drywall anchors alone let it sag and pull away over a few months. We locate the studs and fasten into them.
- The new microwave does not match the old cutout
- The vent opening, the top cabinet depth and the power outlet location differ between brands. We check the template against your cabinet before the day.
- The vent is set to recirculate when it should be ducted
- Grease and steam stay in the kitchen. If a duct already runs to the outside, we connect to it.
- The cord is stretched or pinched
- An outlet inside the upper cabinet is meant to be reached cleanly. We route the cord so it is not bent against the cabinet.
- A built-in model with the wrong trim kit
- The kit has to match the exact model number, or the gaps show and air cannot move around the unit.
- The unit sits too low over the cooktop
- Taller pots do not fit, and heat from the burners reaches the underside. We confirm the clearance before drilling.
The visit
What the installation includes
Starting at $135. The final price depends on the hookups and any parts the job needs, and we confirm it before we start.
- 1
We check the cabinet, the outlet and any existing duct against the new unit.
- 2
We remove the old microwave if you ask and haul it away.
- 3
We mark and drill into the studs, hang the bracket and lift the unit into place.
- 4
We connect the vent, plug in the unit, then run the fan, light and a heating test.
In San Diego
Condo kitchens and older ranges
Many Mission Valley, Downtown and Liberty Station condos pair a small galley kitchen with a microwave above the range, and the building rules sometimes restrict where a vent can discharge. In older La Mesa and Normal Heights kitchens, we often replace a microwave that was hung on a cabinet frame and not on a stud. Tell us the model and we check the mounting template before the visit.
We install microwaves from Samsung, LG, GE, Whirlpool, Sharp, Bosch and other brands, whichever one you bought and wherever you bought it.
Can you replace my old over-the-range microwave with a new one?
Yes. We take down the old unit, check the bracket holes against the new template and fill any extra holes. If the new bracket lines up with the old studs, the swap is quick.
Do you install built-in microwaves with a trim kit?
Yes. Send us the microwave model and the trim kit part number so we can confirm they go together.
Will you install a microwave I bought elsewhere?
Yes, Reset Appliance Repair installs a microwave you bought anywhere. We install appliances from any store.
Can the microwave vent to the outside?
If there is a duct above the range, yes. If not, we set the unit to recirculate and fit its charcoal filter.
Book microwave installation in San Diego.
Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM. San Diego County.