Resources · Viking
Viking Error Codes
Many Viking ovens spell the fault out in words on the display instead of using a number, which makes them easier to read. Older Viking ranges have no electronic display at all and are diagnosed by symptom.
Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM
Viking electronic ovens
These messages appear on Viking ovens with an electronic display. The wording differs slightly between the Professional and Designer series.
| Code | What it means | What to check |
|---|---|---|
| RTD ERROR | The oven temperature sensor is reading open or shorted. | Needs a technician. The sensor is a simple part to replace. |
| PROBE ERROR | The meat probe circuit has a fault. | Remove the probe. If the message clears, replace the probe. If not, the socket or wiring. |
| LATCH ERROR | The door latch did not lock or unlock. | Let the oven cool, switch the breaker off for five minutes and retry. Do not force the door. |
| KEYBOARD ERROR | The keypad is not communicating with the control, or a key is stuck. | Clean and dry the control panel. If it returns, the keypad or ribbon cable. |
| MODEL ERROR | The control does not recognise its model configuration, usually after a board replacement. | Needs a technician to set the configuration. |
Viking dishwashers
| Code | What it means | What to check |
|---|---|---|
| E:01 or flashing lights with water in the base | Overfill or a leak has been detected. | Turn off the water supply and book service. |
Viking refrigeration
| Code | What it means | What to check |
|---|---|---|
| HIGH TEMP / "too warm" | A compartment has been above its safe temperature. | Check the door closes fully and the condenser is clean. Check the food. If it stays warm, book service. |
| oPn / Shr | A temperature sensor circuit is open or shorted. | Needs a technician. |
Codes vary by model and year. If your code is not listed, call (619) 743-9389 with the model number. See also Viking appliance repair in San Diego.
FAQ
Viking code questions
My older Viking range has no display. How is it diagnosed?
By testing. Slow oven ignition points to the igniter, clicking to the spark module or switches, and uneven heat to the thermostat. No code is needed.
What does RTD ERROR mean on a Viking oven?
RTD is the resistance temperature detector, the sensor that tells the control how hot the oven is. The error means its reading is out of range. The sensor or its wiring needs replacing.
Can I reset a Viking oven error myself?
Switch the oven off at the breaker for five minutes. If the message returns, the fault is real and needs repair.
Viking code will not clear? Book a diagnostic.
Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM. San Diego and Orange County.
Call us for a diagnosis.