Resources · Samsung
Samsung Error Codes
Samsung codes are short and the same letter often appears as E or C depending on the model, so 4E and 4C mean the same thing. Most washer codes give you a clear first step. Refrigerator codes are different: Samsung asks you not to unplug the fridge to clear a code unless a step says to, because the stored history helps the technician.
Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM
Samsung washers
A few codes mean different things on different models. Check your user manual if a code looks wrong for the problem you have.
| Code | What it means | What to check |
|---|---|---|
| 4C / 4E / nF | The washer is not filling. | Open both water valves fully, check the hoses for kinks, clean the inlet screens, and make sure the drain hose is only 6 to 8 inches into the drain pipe. Do not use flood-safe hoses. |
| 4C2 / 4E2 / CE | The hot and cold hoses are swapped. | Connect cold to the cold inlet and hot to the hot inlet. No service needed. |
| 5C / 5E / nd / SE | The washer is not draining at the right speed, or at all. | Clean the drain pump filter, check the drain hose for kinks and make sure nothing is clogging the standpipe. |
| OE / OC | Too much water in the drum. | Treat it like a drain problem: filter, hose, standpipe. If water is still rising with the machine off, close the taps and call. |
| UE / Ub / U6 | The load is unbalanced. Ur is only a retry, not a fault. | Spread out and untangle the laundry, close the door and press Start. If it happens on every load, the washer may be out of level. |
| dE / dC / dS / dL | The door is not detected as closed and locked. | Check that nothing is caught in the door and the latch is secure. On some models dC means an unbalanced load instead. |
| LE / 1E / LC | Water level or leak error. | Look for a leak and kinked hoses, then run an empty cycle with no detergent. If suds appear, you are over-dosing or using non-HE soap. |
| SUd / 5Ud | Excessive suds. The washer pauses and resumes by itself. | Use less detergent, and HE detergent only. |
| E2 / bE2 | A panel button is stuck or held down. | Power off and press each button individually, working it back and forth. If one is damaged, it needs service. |
| 3E / 3C | A motor error on most models, a voltage error on some. | Power off for 2 to 3 minutes and restart. If it returns, it needs service. |
| HE / HC / tE | Heater error (HE, HC) or temperature sensor error (tE). | Power off for 2 to 3 minutes and restart. If it returns, the heater or sensor needs testing. |
Samsung dryers
| Code | What it means | What to check |
|---|---|---|
| dC / dE / dF / do | A problem with the door, latch or the sensors that detect them. | Make sure the latch is secure, nothing blocks the door, and the door is fully closed. |
| tS / tC / tO / tE | A temperature problem or a faulty temperature sensor. | Clean the lint screen and the vent system, which are often clogged. If that does not fix it, the sensor needs testing. |
| HC / hE | The dryer is overheating. | Clean the lint screen and vent thoroughly. On an electric dryer, low supply voltage can also cause heating faults, so an electrician may need to check the supply. |
| C80 / C90 / Clg | Results of a vent blockage test: about 80 percent blocked, over 90 percent blocked, or clogged. | The vent needs cleaning from the dryer to the outside before the dryer is used again. |
| 9C1 / 9E / 2E | Abnormal supply voltage. | Use a dedicated circuit with no extension cord. For an electric dryer, have the cord and supply checked. |
Samsung refrigerators
Samsung advises against unplugging the fridge or clearing codes from the panel unless a step tells you to, so a technician can read the stored history.
| Code | What it means | What to check |
|---|---|---|
| 21E | Freezer fan error: the fan is not reporting rotation. | Check that the doors close and seal, and do not overpack the freezer. A frozen fan or a failed fan motor are the usual causes. |
| 22E / 22C | Fridge fan error, sometimes caused by a door left open too long. | Samsung's step is to unplug the fridge with the doors open for a few hours, then plug it in and close the doors. If the code returns, it needs service. |
| 88 88 / 83E / 85E / 86E | Power and voltage faults: 88 88 is a communication fault at start-up, 83E abnormal compressor current, 85E compressor under-voltage, 86E over-voltage. | Switch the breaker off for 60 seconds, then restore power. If the code returns, it needs service. |
| 84C | Compressor lock. | This needs a technician. |
| 39E / 39C | Ice maker function error. | Check the ice bucket is seated. If the code stays, the ice maker needs testing. |
| 40E / 40C | Ice room fan error. | This needs a technician. |
| OF OF / OFF OFF | Cooling Off (demo) mode. Not a fault. | Hold the top two buttons on the left side for 5 to 8 seconds until a chime sounds. The combination varies by model, so check the manual. |
Codes vary by model and year. If your code is not listed, call (619) 743-9389 with the model number. See also Samsung appliance repair in San Diego.
FAQ
Samsung code questions
What is the difference between 4E and 4C on a Samsung?
Nothing in practice. Samsung uses E or C for the same code depending on the model and the display, so 4E and 4C both mean the washer is not filling, and 5E and 5C both mean it is not draining.
Should I unplug my Samsung refrigerator when it shows a code?
Not unless the step for that code says so. Samsung stores the error history in the fridge and a reset can erase it. Write the code down, check the first step for it, and keep the history for the technician.
My Samsung dryer shows C90. Is something wrong with the dryer?
No. After a vent blockage test, C90 reports that more than 90 percent of the vent is blocked. The dryer is working. The vent needs cleaning.
Samsung code will not clear? Book a diagnostic.
Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM. San Diego and Orange County.
Call us for a diagnosis.