Resources · Thermador
Thermador Error Codes
Thermador shares its electronics with Bosch, so many codes match across the two brands, especially on dishwashers. Ovens and induction cooktops show an E code followed by a number.
Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM
Thermador dishwashers
These use the same code family as Bosch dishwashers.
| Code | What it means | What to check |
|---|---|---|
| E15 | Water in the base pan has tripped the leak-protection float. | Turn off the water. The leak must be found before the dishwasher will run. |
| E24 / E25 | The dishwasher cannot drain, or the drain pump is blocked. | Clean the filter, check the drain hose and clear the pump cover in the sump. |
| E09 | Heating circuit fault. | Needs a technician. |
| E22 | Blocked filter. | Remove and wash the filter. |
Thermador wall ovens and ranges
The number after the letter identifies the fault, and the list is different for each oven generation. Always note the complete code.
| Code | What it means | What to check |
|---|---|---|
| E followed by a number | The control has detected a fault. Common groups are temperature sensor faults, door lock faults and overheating in the electronics. | Note the full code. Switch the breaker off for five minutes. If it returns, give the code to the technician. |
| F followed by a number (older models) | Similar fault families on earlier controls: sensor, door lock or control board. | As above. |
| Cooling fan running long after use | Normal. The fan protects the electronics until the oven cools. | No action unless it never stops. |
Thermador induction cooktops
| Code | What it means | What to check |
|---|---|---|
| E9000 / E9010 / U400 | The supply voltage is wrong, or the cooktop is wired incorrectly. | Switch off at the breaker and have the supply and connection checked. |
| E or a flashing symbol on one zone | A sensor fault or an unsuitable pan. | Try induction-compatible cookware. If it persists, it needs service. |
Thermador refrigerators
| Code | What it means | What to check |
|---|---|---|
| Temperature alarm | A compartment has warmed above its limit. | Check the door, press the alarm key to see the highest temperature reached, and check the food. |
| Filter indicator | The water filter is due for replacement. Not a fault. | Replace the filter and reset the indicator. |
Codes vary by model and year. If your code is not listed, call (619) 743-9389 with the model number. See also Thermador appliance repair in San Diego.
FAQ
Thermador code questions
Are Thermador and Bosch error codes the same?
On dishwashers, largely yes, because they are built on the same platform. Ovens and cooktops have their own Thermador codes.
My Thermador oven shows an E code and beeps. What should I do?
Write down the full code, switch the oven off at the breaker for five minutes and restore power. If the code returns, book service and give us the code and the model number.
Where is the model number on a Thermador appliance?
On the rating plate: inside the oven door frame, under the cooktop, on the dishwasher door edge, or inside the refrigerator compartment.
Thermador code will not clear? Book a diagnostic.
Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM. San Diego and Orange County.
Call us for a diagnosis.