Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM

Same-day service

Resources · JennAir

JennAir Error Codes

JennAir shows a lot of display messages that are not faults at all: Sabbath mode, control lock, and a Celsius setting that stops the oven heating above 260 degrees. Rule those out first. The true faults are the F codes, and the first step for nearly all of them is the same: breaker off for one minute, then watch the oven.

Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM

JennAir wall ovens and ranges: F codes

JennAir lists many F-and-E variants, such as F3 E2 or F5 E3. The family number below is the first thing to read. Use your manual for the exact variant.

CodeWhat it meansWhat to check
F1A possible fault in the oven temperature sensor, the control or the wiring.Turn off the range breaker for one minute, turn it back on, and watch for one minute. If F1 returns or the oven will not work, it needs service.
F3 familyA temperature sensor family. F3 E3 points to the oven temperature sensor or its wiring. F3 E2 can also involve a warming drawer sensor.Reset at the breaker. If it returns, the sensor or wiring needs testing.
F9 / F9 E0Usually a wiring problem at the home power supply or hard-wire connection. A power-line disturbance during an outage, or pressing keys within 10 seconds of power-up, can also cause it.If the appliance was installed in about the last three months, have an electrician verify the supply.

JennAir display messages (not faults)

CodeWhat it meansWhat to check
PFA power failure occurred.Press Cancel to clear it. Some models also need the clock reset.
SAB / SabSabbath mode is active.See the manual for entering and exiting Sabbath mode.
LOC / LockedControl lock is on.See the manual for the unlock sequence.
CThe oven is set to show Celsius. It will not heat above 260 degrees in Celsius.Switch the display back to Fahrenheit, using the steps in the manual.
Flashing timePower was interrupted.Press Cancel and reset the clock.

Codes vary by model and year. If your code is not listed, call (619) 743-9389 with the model number. See also JennAir appliance repair in San Diego.

Why does my JennAir oven not heat above 260 degrees?

Check the display for a C. In Celsius mode the oven will not heat above 260 degrees, which is about 500 F. Switch it back to Fahrenheit using the steps in your manual.

What does F9 mean on a JennAir wall oven?

F9 usually points to the power supply, either the household wiring or the hard-wire connection. A power-line disturbance can also trigger it. If the oven is new, have an electrician check the supply before replacing parts.

Can I keep using my JennAir range if the oven shows F1?

F1 points to the temperature sensor, the control or the wiring. Reset it once at the breaker. If it comes back, switch the oven off at the breaker and have it checked.

JennAir code will not clear? Book a diagnostic.

Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM. San Diego and Orange County.

Call us for a diagnosis.

Call Book online