Resources · Dacor
Dacor Error Codes
Dacor wall ovens that use the current control show their faults with a C- prefix, not an F. That surprises people who search for F codes. The meanings below come from the oven manuals. Most of them tell you either to clean the controls and restart, or to call for service.
Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM
Dacor Modernist and Transitional wall ovens
Dacor's own steps for most of these are the same: press Off and restart the oven, and if the code persists, switch off power at the breaker for at least 30 seconds, restore it and try again. If it returns, call for service.
| Code | What it means | What to check |
|---|---|---|
| C-d0 | A control key has been registering as pressed for one minute. | Clean the buttons, wipe off moisture, turn the oven off and retry. |
| C-d1 | The door lock is mispositioned. | Press Off and restart. If it returns, the lock needs testing. |
| C-F0 / C-F2 | Communication between the main board and the sub board (C-F0) or the touch panel (C-F2) was interrupted. | Restart the oven, then switch the breaker off for 30 seconds. If it returns, the board or the wiring needs testing. |
| C-20 / C-21 / C-23 | A sensor circuit fault (open or shorted oven sensor or temperature probe) or an abnormally high internal temperature. | Press Off, restart, and reset at the breaker. If it persists, call for service. |
| C-30 / C-31 | A control board temperature sensor fault, or abnormally high board temperature. | Dacor lists this as call for service. |
| C-A2 | Abnormal cooling motor function. | Call for service. The cooling fan protects the electronics. |
Dacor induction cooktops
Dacor lists these codes in the cooktop manual. Meanings vary by model.
| Code | What it means | What to check |
|---|---|---|
| F0 / F2 | A communication problem between components. | Switch the cooktop off at the breaker for a minute and restart. |
| F1 | The touch control reports an abnormal communication signal. | Make sure the glass is clean and dry, then reset at the breaker. If it returns, it needs service. |
Codes vary by model and year. If your code is not listed, call (619) 743-9389 with the model number. See also Dacor appliance repair in San Diego.
FAQ
Dacor code questions
Why does my Dacor oven show C-F0 instead of an F code?
Dacor uses a C- prefix for oven information codes on the current wall ovens. C-F0 means the main board lost communication with the sub board. A restart and a breaker reset clear it if it was a one-off. If it returns, the boards or wiring need checking.
What does C-d0 mean on a Dacor oven?
A control key has been held or shorted for a minute. It is often moisture or grease on the panel. Wipe the panel, switch the oven off and try again.
Can I keep using a Dacor oven that shows a code?
It depends on the code. A door lock or communication code can stop the oven from running. A high-temperature or cooling fan code means do not use it until it is checked. Switch it off at the breaker and call.
Dacor code will not clear? Book a diagnostic.
Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM. San Diego and Orange County.
Call us for a diagnosis.