Resources · Bosch
Bosch Error Codes
A Bosch error code names the system that has a problem, not always the part that failed. The codes below are the ones we are asked about most in San Diego. Start with the first check. If the code comes back, it needs a diagnosis.
Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM
Bosch dishwashers
Many Bosch dishwashers show a code as E followed by two digits. Newer models may add a second number, such as E24-00.
| Code | What it means | What to check |
|---|---|---|
| E15 | Water has collected in the base pan and tripped the leak-protection float. | Turn off the water supply. Do not keep restarting it. The leak has to be found: a hose, the sump seal, the door seal or oversudsing. |
| E24 | The dishwasher cannot drain. | Clean the filter, check the drain hose for kinks, and check that a new disposal has had its knockout plug removed. |
| E25 | The drain pump is blocked or its cover is loose. | Remove the filter and the pump cover in the sump and clear any glass or debris from the impeller. |
| E22 | The filter is blocked. | Remove and wash the filter assembly. |
| E09 | A fault in the water heating circuit. | This needs a technician. The heater is part of the circulation pump assembly. |
| E01 / E02 / E05 | A fault in the electronic control module. | Switch the power off at the breaker for a few minutes. If the code returns, the module needs testing. |
| E14 | The flow sensor is not detecting water entering. | Check the supply valve is open and the inlet hose is not kinked. |
| E17 / E18 | Water is filling too fast, or not reaching the expected level. | Check the supply valve and the inlet filter. If it persists, the inlet valve or flow sensor may be faulty. |
Bosch washers
| Code | What it means | What to check |
|---|---|---|
| E18 / E-18 | Drain timeout: the washer could not pump out. | Clean the drain pump filter behind the lower front flap and check the drain hose. |
| E17 / E-17 | Water inlet timeout. | Check both taps are open and the inlet hose screens are clear. |
| E23 / E-23 | Water detected in the base. | Turn off the water and call for service. |
Codes vary by model and year. If your code is not listed, call (619) 743-9389 with the model number. See also Bosch appliance repair in San Diego.
FAQ
Bosch code questions
How do I clear an error code on a Bosch dishwasher?
Hold the Start button for about three seconds to reset the cycle, or switch the dishwasher off at the breaker for a few minutes. If the cause is still there, the code will return.
Is E15 on a Bosch dishwasher serious?
It means water is leaking into the base. The dishwasher protects your floor by refusing to run. It needs the leak found and fixed, not just a reset.
Why does my Bosch dishwasher show E24 when the filter is clean?
Check the drain hose and the connection at the sink or disposal next. A small piece of debris under the drain pump cover is another common cause. If those are clear, the drain pump may have failed.
Bosch code will not clear? Book a diagnostic.
Open 7 days Mon–Fri 7 AM–10 PM · Sat 8 AM–10 PM · Sun 8 AM–8 PM. San Diego and Orange County.
Call us for a diagnosis.